This glue is suitable for use with our 3D tile wallpapers for non-absorbent under-surfaces like ceramic tiles.
Its best to moisten the rear of the wallpaper with water first, allowing it to soak in for 10 minutes, then apply this glue directly to the wall over the area you intend to cover.
Attention! Immediately remove any spots of adhesive with clean water!
Edges of the wallpaper should be sealed using clear silicone sealant, to prevent moisture or water from penetrating underneath the wallpaper.
When finished ensure the room is well ventilated.
3D tile wallpaper can easily be cleaned and waterproof once sealed, use normal mild liquid household cleaners and wash off with clean water.
Avoid direct heat eg. gas hobs, acetone & solvents.
750g tub will cover approx. 4-5m if applied thinly.